Tags:
Nov 13

MySolarPlans DIY Solar Panel Guide Walkthrough

If you are planning to start a Do It Yourself (DIY) Photovoltaic (PV) panel project to supplement your home electricity usage, the MySolarPlans web site at www.mysolarplans.com will give you all the instructions you’ll need.

Firstly, the materials inside the members’ area are mainly presented to you via High Definition (HD) streaming videos. The videos are very similar to the clips you see on YouTube but it has much better audio and visual quality. The videos are generally 4 to 6 minutes long.Click Here!

There are a total 7 step by step instructional videos in MySolarPlans teaching you how to make a solar panel from scratch with a minimal budget. But before you begin your homemade PV panel project, make sure you are good with hand tools and also familiar with electrical wiring works.

The most tricky part of the project is learning how to solder individual solar cells together. The dimension of individual PV cell is 3 x 6 inch and you will need at least 18 pieces to make 1 solar panel.

The presenter in the video recommended for you to get the solar cells from eBay because they are relatively inexpensive and it can be shipped anywhere in the world. Nonetheless, if you can get the solar cells from a hardware store around your area, you are free to do so.

By following the instruction from MySolarPlans, you will be connecting 18 pieces to solar cell together so the entire array is capable of generating approximately 70 watt of power. The actual energy output will depend on the quality of the PV cells, the intensity of the sun and even the material used to cover the solar panel.

On my estimation, you should be able to make your own DIY solar panel with a budget of $150 or less. But remember, a readymade solar panel with the same power output will cost upwards of $500! Building your own PV panel is definitely a much cheap alternative.

1 solar panel may not be sufficient for your residential usage. You will need to make at least 4 panels connected together to charge a series of deep cycle batteries. The batteries can then be connected to a power inverter where it will convert the Direct Current (DC) into Alternating Current (AC). Most of your home electrical appliances and electronic gadgets will run on AC.

Personally, the material offered from MySolarPlans in quite useful. Apart from the instructional videos, there are also a complete step by step manual, parts list, tools list, panel diagram and connectivity chart. Everything that you’ll need to get your DIY project started has been included for you.

It is hoped that this MySolarPlans review has been useful for you. Click on the link below to visit the web site right now.

==> Click here to visit MySolarPlans now!

 

Leave a Reply